1. You will need an ATX PSU with at least 10 six-pin PCIe connectors. There are 3 six-pin PCIe connectors on each hashing board and all three need to be connected to the PSU for the hashing board to operate. Do not connect more than one PSU to the same hashing board.
2. Separate power supply to control board: there is one additional six-pin PCIe connector on the IO board which must be connected to the PSU to get power. Be sure to power on the miner only after all the 10 PCIe connectors are connected to a power supply.
Specification of Miner T9+ 10.5TH/s
Specification of APW3++
2.Rated Current(220V input):133A
3.Rated Current(110V input):100A
4.Rated Power(220V input):1600W
5.Rated Power(110V input):1200W
4.Ripple & Noise:<1%
8.Setup, Rise Time:<2S
9.Power off Protection Trip Time:>9mS
10.Interface Type:5 pairs of 6 pin PCI-E connectors (i.e. 10 connectors)
1.Voltage Range:100-240V AC
2.Starting Voltage:95-105V AC
4.Power Factor:>0.95 (full load)
5.Leakage Current:<1.5mA (220V 50Hz)
1.Low-voltage Input:80-89V AC
2.Output Short Circuit:Yes
3.Output Overcurrent:134-185A max.
BITMAIN Antminer T9+ 10.5TH/s ASIC Miner + With APW3++ PSU
- Brands Bitmain
- Product Code: T9+
- Availability: In Stock
- Ex Tax: $473.02